Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Fort Lauderdale, FL
Gate installation in Fort Lauderdale means engineering for salt air, tropical humidity, and a housing stock that ranges from 1950s ranch homes in Poinsettia Heights to custom waterfront estates on Las Olas Isles. We handle the full scope: automatic driveway gates, sliding gates on narrow side-yard lots, electric operators, and the control systems behind them. Most Fort Lauderdale properties sit within a few miles of the Atlantic or the Intracoastal, so corrosion resistance and wind-rated hardware are part of every job we quote, not an afterthought. If you need a gate specialist who understands this city’s conditions, call Miami Gate Company at (833) 570-5807.
Why Fort Lauderdale Homes Are Different
Fort Lauderdale’s gate repair market is dominated by the city’s intricate canal network and waterfront lifestyle, where nearly every property, from the finger islands of Las Olas to the mobile-home communities off Federal Highway, has a driveway gate, boat-lift gate, or pool enclosure gate that must withstand salt-laden air and hurricane-force winds. The constant exposure to Atlantic salt spray and tropical humidity accelerates corrosion on operators, hinges, and sensors, making gate repair here a never-ending battle against rust and electrical shorts that you won’t find inland.
The housing stock compounds the challenge. Mid-century ranch homes in Victoria Park and Poinsettia Heights often have original steel gate frames that were never galvanized for coastal conditions. Condos built in the 1960s and 70s along Galt Ocean Drive run commercial-grade operators that have been patched repeatedly through the decades. Barrier island properties in Harbor Beach and Las Olas Isles carry wide custom aluminum or wrought-iron gates, and those designs demand repair work that respects the original fabrication, not a pull-and-replace approach. After a heavy rain, gate operators along the New River and in low-lying areas like Sailboat Bend often short out because water pools around underground conduits, a problem that rarely occurs on higher ground west of I-95.
We keep repairs grounded in what these specific neighborhoods actually throw at us. That means different hinge alloys near the Intracoastal, different photo-eye mounting heights in flood-prone lots, and different operator enclosures for condos that face open ocean wind. We’ve worked this city long enough to know the difference between a gate problem and a Fort Lauderdale gate problem.
Styles & brands we work with
Our Main Fort Lauderdale Services
Most calls we take in Fort Lauderdale fall into two categories: a mechanical gate that won’t move correctly, and an electric operator that has lost its mind. Both are covered below, with dedicated Fort Lauderdale pages for each.
Gate Repair in Fort Lauderdale
Mechanical gate repair in Fort Lauderdale usually means one of three things: hinge wear from years of salt exposure, track misalignment after a storm pushed the gate frame, or a post that has shifted in sandy soil. We rebuild welded corners, replace worn rollers and hinges, realign tracks on concrete and paver driveways, and adjust cantilever and V-track sliding gates. On older properties in Poinsettia Heights and Victoria Park, we frequently see original steel hardware that has thinned so much it fails during a routine open-and-close cycle. The fix is straightforward: replace the worn parts with marine-grade hardware before the gate drops. Gate Repair in Fort Lauderdale covers mechanical repair in depth.
Electric Gate Repair in Fort Lauderdale
Electric gate issues in Fort Lauderdale run deeper than a dead remote battery. We diagnose at the component level: the motor, control board, safety sensors, loop detectors, and the wiring that ties them together. Salt corrosion on terminal blocks, ants nesting inside operator enclosures, and water intrusion from afternoon thunderstorms are the three culprits we see most. A gate that opens but won’t close is often a photo-eye that’s misaligned or fogged over from humidity; a gate that hums but won’t move usually points to a capacitor or a seized gearbox. We fix what you have rather than pushing a replacement. Electric Gate Repair in Fort Lauderdale walks through our diagnostic approach.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Fort Lauderdale
Gate installation in Fort Lauderdale is rarely a simple bolt-on job. The soil near the Intracoastal runs sandy, the wind load on a wide driveway gate can exceed what inland installers ever plan for, and corrosion starts the day the gate goes in. We design each installation for these conditions from the first measurement. Whether you’re adding a sliding gate to a narrow side yard in Victoria Park or an automatic estate gate in Harbor Beach, we handle the full scope: fabrication, operator selection, electrical, safety edges, loops, and programming. We don’t subcontract the gate portion to a fencing crew; gates are what we do. For a complete look at our installation services, see Gate Installation.
Automatic Gate Installation
Signs you need it
You’re still opening your driveway gate by hand, or a contractor told you your old manual gate can’t support an operator without being rebuilt.
What it costs in Fort Lauderdale
Automatic gate installation with a new operator, safety devices, and basic electrical typically runs $4,800 to $8,600 in Fort Lauderdale depending on gate length and access to power.
How we do it
We measure the gate and travel path, check the posts for wind-load capacity, pull the electrical run, mount the operator, wire the safety edges and photo-eyes, and program remotes and keypads before a full cycle test.
Driveway Gate Installation
Signs you need it
Your current driveway gate is rusted through at the bottom rail, the posts lean inward after years of wind, or you want a wider opening for a boat trailer or delivery trucks.
What it costs in Fort Lauderdale
Driveway gate installation in Fort Lauderdale generally falls between $3,200 and $7,500 depending on gate material, width, and whether you’re automating it at the same time.
How we do it
We pull the old gate and posts, set new posts in concrete rated for sandy coastal soil, hang the gate with marine-grade hinges, and adjust the level and swing before securing everything in place.
Sliding Gate Installation
Signs you need it
Your lot has a short setback or a sloped driveway where a swing gate would bind, and you need a gate that tracks sideways instead of arcing outward.
What it costs in Fort Lauderdale
Sliding gate installation runs $3,600 to $8,200 in Fort Lauderdale, with the higher end covering longer spans and operators that exceed the usual residential duty cycle.
How we do it
We lay the track on a level concrete base, set the guide posts and end stops, mount the gate, install the receiver and limit switches, and tune the opener for clean travel every cycle.
What Gate Installation Costs in Fort Lauderdale
| Item | Typical range in Fort Lauderdale |
|---|---|
| Automatic gate installation | $4,800 – $8,600 |
| Driveway gate installation | $3,200 – $7,500 |
| Sliding gate installation | $3,600 – $8,200 |
How long does gate installation take in Fort Lauderdale?
Most residential gate installations in Fort Lauderdale take two to four days from tear-out to programming. Custom fabrication, HOA approval, and electrical upgrades can add a week or more.
Do you need a permit to install a gate in Fort Lauderdale?
Many Fort Lauderdale neighborhoods require a permit for an automatic driveway gate, and some HOAs must approve the design before work starts. We confirm the requirements for your specific address before we quote.
Brands We Service in Fort Lauderdale
We work on Ghost Controls, DoorKing, Elite, and Mighty Mule systems every week in Fort Lauderdale, plus FAAC, BFT, LiftMaster, Linear, and Viking. We keep common control boards, photo-eyes, and receiver modules stocked locally so a diagnosed failure doesn’t mean waiting a week for parts. Our brands page lists the full lineup.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Fort Lauderdale, FL
| Service | Typical range in Fort Lauderdale |
|---|---|
| Gate repair | $85 – $380 |
| Electric gate repair | $60 – $220 |
| Automatic gate installation | $4,800 – $8,600 |
| Driveway gate installation | $3,200 – $7,500 |
| Sliding gate installation | $3,600 – $8,200 |
| Operator wiring / electrical repair | $120 – $450 |
| Control board replacement | $200 – $650 |
| Photo-eye sensor replacement | $85 – $220 |
| Gate operator replacement | $650 – $1,600 |
| Track realignment | $95 – $280 |
Prices in Fort Lauderdale push toward the higher end when a job involves long steel gate spans near the water, custom wrought-iron fabrication, or electrical runs that cross paver driveways where trenching costs more. You’ll always get a written price agreed before any work begins, no surprise line items on the invoice afterward.
Neighborhoods We Serve in Fort Lauderdale
We run gate service across Fort Lauderdale, from the canal-front streets of Las Olas Isles to the solid mid-century blocks of Poinsettia Heights. Our techs know the difference between a Harbor Beach estate gate and a Sailboat Bend courtyard gate, and we stock for both.
- Las Olas Isles
- Victoria Park
- Poinsettia Heights
- Harbor Beach
- Sailboat Bend
Most Fort Lauderdale calls get a same-day or next-day visit depending on the area and the day’s schedule.
Service Area – Cities Near Fort Lauderdale
From our Fort Lauderdale work, we also cover nearby Broward communities. We regularly repair and install gates in Plantation, FL, Broadview Park, FL, Broward Estates, FL, and Lauderhill, FL. The same techs and the same upfront pricing apply.
Serving Fort Lauderdale, FL — Our Local Coverage Area
We’re based in the Fort Lauderdale area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Fort Lauderdale
We schedule most Fort Lauderdale repair calls within one business day, and emergency gate-down situations get priority routing when you call. Morning calls generally get same-day slots in most neighborhoods we serve.
Yes. Many Fort Lauderdale HOAs, especially in gated communities off Federal Highway and in newer condo developments, require pre-approved gate designs and licensed electrical work. We coordinate the paperwork and the repair or installation so the gate meets the association’s standard.
We service and install boat-lift gates and pool enclosure gates throughout Fort Lauderdale. These jobs require marine-grade hardware and close attention to salt corrosion, which is exactly the environment we’re built for.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Fort Lauderdale Customers Say
"Solar panel on our remote gate wasn't keeping the battery up through the winter. He repositioned it, replaced the battery, and explained the math on why the old placement was never going to work."
— Ryan Miller"Hinge post had rotted at the base and the whole swing gate was sagging into the concrete. He rebuilt the post rather than talking us into a whole new gate, which two other companies had pushed for."
— Arjun Sharma"Photo eye was misaligned so the gate refused to close after dark. Ten minute fix. He also cleaned the lens and pointed out that the sprinkler head was spraying it every morning, which is why it kept happening."
— Chris Norris