Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Electric Gate Repair Across Fort Myers Shores
Electric gate repair in Fort Myers Shores usually means one thing: a gate that sat too close to the Caloosahatchee River or one of its canals and finally gave out. We fix motors, control boards, keypads, remotes, safety sensors, and the structural problems that salt air and muck create. If your gate is dragging, shorting, or refusing to open, call us at (833) 570-5807 for a free estimate. We know the canal-front lots, the older ranch homes, and the specific ways Fort Myers Shores gates fail.
Key Takeaways
- Fort Myers Shores gate problems run deep: sinking posts, corroded boards, storm damage, salt spray.
- Gate motor repair runs $225 – $480 in this market; control board replacement runs $380 – $650.
- We reset hinge posts to deeper footings than inland work because canal-bank soil shifts after every storm.
- Miami Gate Company services Gate Motor Repair, Opener Repair, Keypad Repair, Remote Control Repair, Safety Sensor Repair, and Control Board Repair.
- Ruben Castellano leads a team that fixes what you already have, brand-agnostic, no sales push.
Styles & brands we work with





Why Miami Gate Company Is Fort Myers Shores’s Preferred Electric Gate Repair Company
We are a gate company. That is all we do. The difference matters in Fort Myers Shores because this is not a place where a general handyman’s guess holds up. Our Electric Gate Repair team diagnoses at the component level: the motor, the board, the safety loop, the photo eyes, the wiring. Not just the obvious part somebody hopes is the problem. Ruben Castellano built the company around the idea that people deserve a straight answer about their gate, not a sales pitch for a replacement they do not need.
Fort Myers Shores customers tell us the same thing: the gate worked fine until a storm, or until the post shifted, or until the salt finally ate through a connection. We arrive, we find the actual fault, and we quote a price before any work starts. You approve it, we do the work. No invoice surprises at the end.
Automatic Gate Repair in Fort Myers Shores
Automatic gate repair in Fort Myers Shores often starts with a gate that either will not open, opens halfway and reverses, or beeps and does nothing. On canal-front properties, we check the operator first, then the post footing. A gate that has sunk into soft soil will strain the motor and trip the overload repeatedly, even if the motor itself is fine. Repairs typically run $175 – $395 depending on whether the issue is a sensor, a board, a wiring fault, or a post reset.
Swing gate sag and drag
Fort Myers Shores has a lot of older iron swing gates on 1960s and 1970s ranch lots. When the lower hinge wears or the post leans, the gate drags. We straighten or reset the post, replace hinges, and rebalance the leaf so the operator is not fighting a losing battle.
Storm-related operator failures
Summer thunderstorms in this part of Lee County are intense. Water forces its way into conduit, junction boxes, and sometimes the operator housing itself. We open everything, dry out what can be saved, replace what cannot, and seal the enclosure.
Electric Gate Motor in Fort Myers Shores
Electric gate motor replacement or repair in Fort Myers Shores is a common call because the humidity and salt spray shorten motor life even when the gate itself is sound. A motor that hums but will not move, or one that smells burnt after a heavy rain, needs attention before it takes the control board down with it. Motor repair runs $225 – $480; full motor replacement averages $550 – $900 installed in this market.
Humming, straining, tripping
When we hear that a gate motor in Fort Myers Shores is humming, our first thought is usually the capacitor or a bind in the gate travel. We test the motor draw. If the gate is binding because a post sank, a new motor will fail the same way. We fix the bind first.
Board and motor matching
Older operators often have a perfectly good motor but a tired control board, or a good board and a seized motor. We diagnose which is which and replace only what is dead. That brand-agnostic approach means we are not pushing a whole new operator when a $400 board will give you another five years.
Trusted Brands We Service in Fort Myers Shores
We work on Ghost Controls, DoorKing, Elite, Mighty Mule, and more, plus the bigger commercial names. Because we are brand-agnostic, we fix what you have. Many Fort Myers Shores gates are Ghost Controls or Mighty Mule units installed over the last decade, and plenty of older DoorKing and Elite operators still hold up structurally while their boards age out. We keep common boards and safety eyes in the truck and can have less common parts in a day or two.
See the difference
Before
After
Before
After
Before
AfterCommon Electric Gate Repair Problems We See in Fort Myers Shores Homes
- Hinge posts sinking into canal-bank muck. Heavy rain turns the soil soft, and a swinging gate pulls its post out of plumb. We reset the post to a deeper footing and repack the base so it stays put.
- Rusted bottom rails and hinge hardware. Salt-laden air from the river and boat traffic eats through painted welds first. The bottom rail collects moisture and rusts through at the joints, and then the gate drops.
- Photocell and safety sensor failures. The salt film that builds up on sensor lenses eventually corrodes the wiring terminals behind them. Your gate thinks something is in the way and reverses.
- Operators shorting after heavy rain. Fort Myers Shores gets intense afternoon thunderstorms. Water finds its way through old conduit seals and into the operator. We rebuild, seal, and test under real load.
Pricing for Electric Gate Repair in Fort Myers Shores, FL
Fort Myers Shores repair work runs a little higher than inland Lee County because the labor includes more structural remediation and corrosion work. A typical gate motor repair runs $225 – $480. Control board replacement runs $380 – $650. Safety sensor replacement runs $150 – $300 per sensor. Keypad and receiver replacement runs $180 – $350. Full post reset with concrete footing runs $450 – $800 depending on access and depth. Steel repair and reinforcement runs $250 – $600. These are not list prices pulled from a national site; they are what this market actually costs. We quote the full price before work starts and you approve every dollar.
We Also Serve Cities Near Fort Myers Shores
Our service trucks cover not just Fort Myers Shores but also Fort Myers Shores neighbors like Buckingham, Olga, Gateway, and Tice. The same brand-agnostic repair approach, the same component-level diagnosis. Wherever your gate sits in this part of Lee County, we can get to it.
Serving Fort Myers Shores, FL — Our Local Coverage Area
We’re based in the Fort Myers Shores area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in Fort Myers Shores
Salt spray from the Caloosahatchee River, Gulf breezes, and constant boat traffic near the Rubicon canal system carries fine salt particles onto your gate hardware, where they collect in hinges, welds, and screw heads. Painted steel hinges rust through in as little as 18 months here. We replace them with stainless fixings and use galvanised hardware so you are not back in this situation next year. Call (833) 570-5807 for an assessment.
Yes, and Fort Myers Shores is worse than inland Lee County because many gates sit lower and closer to the water. Storm water intrudes through old conduit, junction boxes, and the operator enclosure itself. We dry the unit, replace the board if it is dead, and seal the enclosure properly. If your operator went dead after the last storm, estimates are free.
Your hinge post has likely sunk into the soft canal-bank soil after heavy rain, pulling the gate down. This happens constantly along the canal network. The fix is not a new operator; it is pulling the post, going deeper with the footing, and resetting the gate level. A dragging gate will kill any operator.
We do it regularly. Canal-front access in Fort Myers Shores means working around the sloped bank, often with the gate close to the water line. We reset posts deeper than inland specs and use stainless fixings as standard on these jobs. It takes a little longer, but it actually fixes the problem so the gate stays level through next year’s storms.
Three things: seal every conduit entry point, use dielectric grease on board connections, and upgrade to a gasketed enclosure if the operator sits within sight of open water. We do all three during a repair. It will not make the salt go away, but it will keep it out of the board and terminals. Call us for an exact quote; estimates are free.
Written by Ruben Castellano, Owner at Miami Gate Company, serving Fort Myers Shores and the wider Lee County area.