Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Electric Gate Repair Across Conway
Electric gate repair in Conway usually means one of three things: a motor that quit, a gate that drags on the ground, or an operator that opens but won’t close. Most calls we run in the 32812 area trace back to post movement or storm damage, not a dead motor. We work on virtually any gate system, whatever brand you have, and we diagnose the motor, board, sensors, and wiring, not just the obvious parts. If your gate is stuck, grinding, or refusing to close after a storm, call us at (833) 570-5807. We know Conway’s soil, its weather, and the way both of them treat a gate system.
Why Miami Gate Company Is Conway’s Preferred Electric Gate Repair Company
We are a gate-only shop. That distinction matters in a place like Conway, where most homes sit on lake-adjacent or canal-side lots and the ground does things that a generalist handyman has never seen. Every technician on our team is trained on gate mechanics and automation specifically. We do not split our attention across fencing, garage doors, or unrelated trades. Gates are all we do, and that focus shows in the diagnosis.
Conway homeowners and property managers call us because we understand the local failure pattern. On lake-adjacent and canal-side lots, the sandy soil reworks itself every summer rainy season. Gate posts heave. Hinge posts pull loose within a year of a clean install. The gate drags, the operator faults on travel limits, and the homeowner assumes the motor died. It usually did not. We start at the footing and the hinge post before we ever condemn a board or a motor. That local knowledge saves Conway customers from paying for a motor replacement they did not need.
We also work on the full range of residential and commercial systems across Conway, from a Mighty Mule on a side-yard gate near Lake Conway to a commercial slide gate off Hoffner Avenue. Our team, led by Ruben Castellano, has built a reputation in this area for showing up, finding the actual cause, and fixing it without pushing an unnecessary replacement. Brand-agnostic means we fix what you have. We are not here to sell you a system you do not need.
Styles & brands we work with
Electric Gate Motor in Conway
An Electric Gate Motor in Conway takes a beating from two directions: subtropical humidity that corrodes connections and wind load that forces the motor to work harder than it was ever rated for. When a motor fails here, the job involves testing the capacitor, checking the control board output, verifying the limit switches, and confirming the motor is receiving proper voltage. We also check whether the gate itself moves freely by hand, because a motor straining against a sagging gate on a heaved post will burn out repeatedly until the footing is corrected.
When a Motor Needs Repair vs. Replacement
Many Conway calls start as a motor that hums but will not move, or a motor that runs but stalls halfway through travel. We open the unit, test the windings and the start capacitor, and look for water intrusion at the conduit. If the motor is sound and the board is commanding it correctly, we repair the mechanical issue and the motor stays. If the armature is burned or the gearbox is stripped from someone forcing a storm-locked gate, replacement is the honest call. We quote the price before we touch anything.
Repair Cost Realities
A gate motor capacitor replacement in Conway typically runs $140 to $230. A full motor swap, depending on the brand and whether we are keeping your existing control board, usually lands between $650 and $1,450 installed. We tell every customer the number up front, in writing, before any work begins.
Gate Access Control in Conway
Gate Access Control in Conway covers the keypads, intercoms, remote transmitters, loop detectors, and safety photocells that tell the gate when to open and when to stay put. On the residential side around Lake Conway, most systems are a simple keypad plus a couple of handheld remotes. On commercial properties and a few larger estates, we see telephone entry and vehicle detection loops. The common thread in this climate: moisture in the keypad housing, corroded terminal strips, and lightning-adjacent surge damage to the receiver board during summer storms.
Keypads, Remotes, and Surge Damage
A Conway keypad that quits after a thunderstorm usually has a fried surge protector or a wet ribbon cable, not a bad keypad. We test the keypad output at the board, check the receiver for surge marks, and re-program remotes only after the power side is confirmed clean. Replacing a keypad on an existing system here generally runs $180 to $320.
Loop Detectors and Safety Photocells
Commercial slide gates in Conway rely on loop detectors buried in the driveway. When the sandy soil shifts, the loop wires can stretch or break, and the gate will not open for exiting vehicles. We trace the loop, find the break, and often can repair the wire without replacing the entire loop. Photocell misalignment from post movement is another frequent fix. We re-align, confirm the entrapment protection is active, and test the gate under load.
Trusted Brands We Service in Conway
We work on virtually any gate system, and our Conway service truck carries parts for LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. That matters when a Electric Gate Repair call comes in from a homeowner with a Ghost Controls swing arm that will not respond or a DoorKing slide operator that trips its breaker. Because we stock common boards, remotes, and photocells locally, much of the repair work our team handles in Conway gets completed on the first visit. Multi-brand training means we do not have to call a factory rep to diagnose a BFT board or an Elite limit switch. We just fix it.
Common Electric Gate Repair Problems We See in Conway Homes
- Heaved hinge posts from lake-adjacent soil movement. This is the single most common call we run in 32812. After summer rains, posts pull loose or lift, the swing gate drags, and the operator faults on travel limits. The fix starts at the footing, not the motor.
- Storm-locked operators after a power cut. Wind and lightning knock out power across Conway, and owners who never learned the manual release force the gate and bend arms or strip the gearbox. We re-set the arm, repair the gearbox if needed, and show you the safe release procedure.
- Rust-through on older wrought-iron gates. Subtropical humidity and thunderstorm wind load accelerate rust on solid infill panels. Hinges freeze, the rack and pinion on slide gates stress, and the whole system works harder than it should. We cut out and weld in new sections or replace the hinge hardware before it fails completely.
- Photocell misalignment from post movement. When a post shifts even a quarter inch, the safety beam stops seeing the reflector and the gate refuses to close or reverses halfway. We realign, tighten, and verify the entrapment protection is active.
See the difference
Before
After
Before
After
Before
AfterPricing for Electric Gate Repair in Conway, FL
We quote every repair in writing before any work starts. The number we give is the number you pay, agreed in advance. For Conway specifically, gate motor capacitor replacement runs $140 to $230, keypad replacement $180 to $320, and a full operator motor swap typically lands $650 to $1,450 installed depending on brand and whether we retain your existing control board. Full installations are measured and scheduled, not estimated on the phone, so call us for a free measure and a written price. Commercial slide gate work and loop detector repair are quoted after we inspect the site. Estimates are always free at (833) 570-5807.
We Also Serve Cities Near Conway
Our crew covers Electric Gate Repair in Conway and the surrounding area, including Azalea Park, Belle Isle, Edgewood, and Pine Castle. If your gate is acting up and you are in one of those neighborhoods, the same team, the same truck, and the same gate-only focus applies. Call us and we will route the nearest technician to you.
Serving Conway, FL — Our Local Coverage Area
We’re based in the Conway area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in Conway
You can release it safely, but only if you know the release mechanism on your specific operator. Most operators have a manual release key, pull handle, or release lever on the operator body. Pull the lever to the release position for your model, wait for the spring tension to settle, and only then move the gate by hand slowly. Never try to force a locked gate open by leaning into it or using a vehicle, because that is how arms get bent and gearboxes stripped. If you cannot find the release or you have already forced it, call us at (833) 570-5807 and we will get your gate moving without further damage.
The usual culprit is a misaligned photocell or a dragging gate, not a bad board. In Conway, the sandy soil under lake-adjacent lots shifts after heavy rain, the hinge post moves, and the gate edge catches the ground or the track. The operator reads the increased resistance as an obstruction and reverses. We realign the posts, check the cell beam, and re-teach the travel limits.
Yes. Entrapment protection is required equipment on any automatic gate operator, and a gate that reverses or crushes without sensing an obstruction is a serious safety hazard. We test photocells, edge sensors, and the force settings on every Conway repair call before we leave.
We can, and we see this constantly on Conway’s older mid-century lots. We cut out the rusted sections, weld in new material, replace the hinge hardware, and then reassess the operator’s travel. If the rust froze the hinges and the motor has been straining, we check the capacitor and the limit settings after the mechanical side is corrected.
If the gate is just a spring-loaded pool gate, no, that is a mechanical hinge and latch repair. But if the enclosure has an electric operator, keypad, or maglock, then yes, and the same Florida pool-safety requirements apply. We fix the operator and confirm the gate self-closes and self-latches to code. Call us if you are not sure which system you have.
Contact Miami Gate Company for Electric Gate Repair in Conway
We work on gates all over Conway, from Ranch Road to the streets off Michigan Avenue, and we know the local failure pattern: it is usually the ground, not the motor. We diagnose the motor, board, sensors, and wiring, and we quote every repair before we start. We work on virtually any gate system, and we stock parts for LiftMaster, FAAC, BFT, DoorKing, Ghost Controls, Elite, and Mighty Mule, so most Conway repairs finish on the first visit. Electric gate acting up? Call (833) 570-5807 for a free estimate and a straight answer.
Written by Ruben Castellano, Owner at Miami Gate Company, serving Conway and the greater Orlando area.